裝載機夏季高溫如何安全使用？

1、為了確實保證裝載機的冷卻系統效能良好，在進入夏季以前，應對冷卻系統的各個部件進行徹底的清理、緊固和潤滑，盡可能的清理冷卻系統水垢(包括散熱器內的水垢清理干凈)，以提高散熱效能，保持冷卻系統暢通和加速冷卻水的循環。
In order to really ensure the effectiveness of the cooling system loader Shandong good in the summer before, to deal with the various components of the cooling system for a thorough cleaning, tightening and lubrication, cooling system

as much as possible to clean up the scale (including scale clean the radiator) to improve the cooling efficiency, cooling systems to maintain and accelerate the flow of cooling water circulation.

2、檢查裝載機水泵一風扇傳動皮帶，皮帶經長期使用后，皮帶會產生疲勞、變形，降低冷卻效果，皮帶更換時，要注意型號和長度，并正確調整其松緊度。
Check Shandong loader pump a fan belt, a belt after long-term use, the belt will produce fatigue, deformation, reduce the cooling effect, belt replacement, pay attention to the type and length, and properly adjust the tightness.

3、檢查裝載機水箱連接膠管，水箱的膠管的耐油性比較差，容易早期損壞，從而影響供水量，引起發動機溫度升過高。檢查有破裂和漏水現象，要及時排除，同時要保持足量的冷卻水，發現不足要及時添加。
Check the hose connection Shandong loader tank, oil tank hose rather poor, easy early damage, thus affecting the water supply, causing the engine temperature rises too high. Check for cracks and water leakage, should be promptly

removed, while maintaining a sufficient amount of cooling water was found to be insufficient time to add.

4、進入夏季之前，要有針對性的對裝載機潤滑系統的各個部件做一次性能檢測，以使機油壓力表、變速箱壓力表指示準確。對變速箱、變距器和驅動橋內的油液進行一次系統的檢查，從油液的品質到油液的數量，并要保持油液清潔。
Before the summer, we have targeted various parts of Shandong loader lubrication system to do a performance test, so the oil pressure gauge, pressure gauge accurate transmission. Gearbox, pitch and drive axle oil within a system of

inspection, from the quality of the oil to the amount of oil, and to keep the oil clean.

5、為保證裝載機的正確使用，要時刻注意水溫表的讀數，達到90°以上時必須采取措施?？蛇x擇就近的陰涼處停車并以怠速降溫，注意不要即刻熄火，以防止發動機內部過熱而造成拉缸等事故。待溫度降下來后，還應檢查風扇皮帶的張力情況。
To ensure proper use of Shandong loader, should always pay attention to the readings of water temperature, when reached more than 90 ° must be taken. Choose the nearest parking shade and cool at idle, be careful not to turn off

immediately to prevent overheating and cause internal engine pull tanks and other accidents. After the temperature down, you should also check the fan belt tension.

6、夏季行車中，裝載機輪胎層數多為14層左右，和大型輪胎相比傳熱較快，很容易發生輪胎過熱，使內壓增高，促使輪胎的橡膠物理性能下降，以至于引起爆胎。如發現輪胎氣壓、輪胎溫度過高，應將車停在陰涼處降溫后再繼續行駛。
Traffic in the summer, Shandong loader tire is about 14 layers thick layers, and large tires compared to heat faster, it is prone to overheating of the tire, the internal pressure increased, prompting the physical properties of rubber tires fall that caused a puncture . If found tire pressure, tire temperature is too high, it should be parked in the shade to cool and then continue driving.