裝載機的水箱如何進行修理?
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：364次
裝載機的水箱出現問題的話就會影響使用，所以及時的進行修理才是關鍵，下面永保裝載機的專家就給大家詳細分析一下裝載機的水箱如何進行修理?
1、檢查裝載機的水箱的水位時，發動機熄火，并等待發動機和水箱冷卻后進行檢查，檢查副水箱的水位，一般情況下，不要打開水箱蓋。
Check the water level of the water tank of the loader, the engine off, and wait for the engine and the water tank to check, check the water level of the sub tank, under normal circumstances, do not open the tank cover.
2、如裝載機沒有副水箱，則必須取下水箱蓋，并遵循下列操作說明。
If the loader does not have an auxiliary water tank, the water tank cover must be removed and the following operation instructions must be followed.
3、檢查裝載機水箱水位降低后才能檢查水位，把手靠近發動機和水箱檢查周圍空氣溫度，不能將手直接接觸發動機和水箱。
Check the water level of the loader water tank to check the water level, the handle near the engine and the water tank to check the ambient air temperature, can not directly contact the engine and the water tank.
4、先松動裝載機水箱蓋將水釋放壓力，然后慢慢的取下水箱蓋。
Loosen the water tank cap of the loader to release the water pressure, and then take off the lid of the water tank.
