調整裝載機離合器的方法
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：571次
1、分離杠桿位置的調整
在安裝裝載機離合器時必須首先保證分離杠桿的內端面到飛輪外端面的距離為(89±1)mm，同時要保證三個分離杠桿的內端面在同一垂直于軸線的平面內，互差不大于0.2mm，調整時，先松開鎖緊螺母，旋轉調整螺釘，使三個分離杠桿高度一致，調整完用螺母擰緊阿特拉斯空壓機配件。
In the installation of Shandong loader clutch must first ensure that the separation distance of the lever of the inner end face of the flywheel end is (89 + 1) mm, at the same time to ensure that the inner end face of the three separate lever in with a perpendicular to the axis of the plane, the mutual difference is not greater than 0.2mm, adjust, loosen the lock nut, the rotation adjustment screw, three separate lever highly consistent, adjustments are done and tightened by a screw of atlas air compressor fittings.
2、離合器踏板自由行程的調整
裝載機分離杠桿與分離軸承工作端面的間隙應為2mm，此間隙稱為分離間隙，它相應于踏板自由行程30mm，如不符合時，可松開拉桿上的兩個鎖緊螺母，然后轉動拉桿，以改變拉桿的長度，使之滿足分離間隙的要求，調好后將鎖緊螺母擰緊。
Shandong loading machine release lever with release bearing working surface gap should be 2mm, gap here called for separating gap corresponding to pedal free travel 30mm, such as does not conform to, release the bar two lock nut, then turn the rod, to change the rod length, so as to meet the requirements of the gap separation, after a good tune will lock nut tightened.
